Hi everyone,
I am currently working on a testbench and I need to be able to produce different level of tensions depending on which part of the sequence I am in with an ni PXIe 6555 using HSDIO.
This goes like this:
seq_A>seq_B>seq_C...
A uses 0-3.3V
B uses 0-5V
C uses a custom level
I already use all my channels so I can't switch channels in order to find a go around solution and they are already set to a dynamic generation since I am using waveforms. At the moment I have all the results with the sequences when I do it one by one but I can't seem to find a way to do it fast.
I already succeeded in doing them one at a time, unload the waveform, reconfigure, upload the new one but the timing in between is way too long, it takes 3ms for all of this to be done so I am looking for a more optimal solution which could run smoothly.
I tried using different vi, one for each sequence, produce them and then generate, wait until it's done, generate... but it is bugging without an error message.
If you have any idea of how to proceed, thanks for the help!