I am currently wanting to use my DSO-X4104A to measure 3x sinusoidal signals simultaneously. I want to measure these three signals over a couple of seconds, save all the data for each channel and pass it off into LabWindows via USB with VISA commands. Then, take all the data points and calculate information relative to each signal. The only problem is, I have no idea how to do this.
I guess the first question I have is to know "where" or "what" stores data in the oscope for multiple channel readings with respect to the same time interval. Is there common terminology or something I should look for in the programming manual of my oscope?
The other question is whether or not LabWindows will be able to read this "data block" and then tell the oscope, "Ok I've got what I want, now clear this data and lets measure some more stuff again."
I also don't need a terribly high amount of data points as the signals are all 400Hz and will be used in calculating phase information.
Thanks,
Alex